Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 13)

LSI Corporation
- 13 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Controller Commands
storcli /cx set consistencycheck|cc=[off|seq|conc][delay=value]
[starttime=yyyy/mm/dd hh] [excludevd=x-y,z]
storcli /cx set clusterenable=
storcli /cx set copyback= type=<smartssd|smarthdd|all>
storcli /cx set directpdmapping=<on|off>
storcli /cx set eccbucketleakrate=
storcli /cx set eccbucketsize=
storcli /cx set enableeghsp=<on|off>
storcli /cx set enableesmarter=
storcli /cx set enableeug=<on|off>
storcli /cx set exposeencldevice=<on|off>
storcli /cx set dimmerswitch|ds=
storcli /cx set foreignautoimport=<on|off>
storcli /cx set jbod=<on|off>
storcli /cx set loadbalancemode=
storcli /cx set maintainpdfailhistory=<on|off>
storcli /cx set migraterate=
storcli /cx set ncq=<on|off>
storcli /cx set patrolread|pr {=on mode=}|{off}
storcli /cx set perfmode=
storcli /cx set pi=<on|off>
storcli /cx set preventpiimport=<on|off>
storcli /cx set prcorrectunconfiguredareas=<on|off>
storcli /cx set prrate=
storcli /cx set rebuildrate=
storcli /cx set restorehotspare=<on|off>
storcli /cx set smartpollinterval=
storcli /cx set spinupdelay=<value>
storcli /cx set spinupdrivecount=
storcli /cx set stoponerror=<on|off>
storcli /cx set usefdeonlyencrypt=<on|off>
storcli /cx set time=yyyymmdd hh:mm:ss|systemtime
storcli /cx set usefdeonlyencrypt=<on|off>
The following table lists and describes the properties for the show and set commands.
Table 4 Properties for Show and Set Commands
Property Name Set Command Range Description
abortcconerror on|off Aborts consistency check when it detects an
inconsistency.
activityforlocate on|off Enables/disables drive activity, drive activity locates
function for systems without SGPIO/SES capabilities.
alarm on|off|silence
silence : Silences the alarm.
Enables/disables alarm on critical errors.
backplane 0 : Use autodetect logic of backplanes,
such as SGPIO and I2C SEP using GPIO
pins.
1 : Disable autodetect SGPIO.
2 : Disable I2C SEP autodetect.
3 : Disable both the autodetects.
Configures enclosure detection on a non-SES/expander
backplane.
batterywarning on|off Enables/disables battery warnings.
bgirate 0 to 100 Sets background initialization rate in percentage.