Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 18)

LSI Corporation
- 18 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Controller Commands
storcli /cx set patrolread [delay=]
This command delays the scheduled patrol read in hours.
Input example:
storcli /c0 set patrolread delay=30
storcli /cx show patrolRead
This command shows the progress on the current patrol read in percentage.
Input example:
storcli /c0 show patrolread
storcli /cx start patrolread
This command starts the patrol read operation. This command starts a patrol read immediately.
Input example:
storcli /c0 start patrolread
storcli /cx stop patrolread
This command stops a running patrol read operation.
Input example:
storcli /c0 stop patrolread
storcli /cx suspend patrolread
This command pauses a running patrol read operation.
Input example:
storcli /c0 suspend patrolread
4.2.3.3 Consistency Check
The Storage Command Line Tool supports the following commands to schedule, perform, and view the status of a
consistency check (CC) operation:
storcli /cx set consistencycheck|cc=[off|seq|conc][delay=value]
starttime=yyyy/mm/dd hh [excludevd=x-y,z]
storcli /cx show cc
storcli /cx show ccrate
The detailed description for each command follows.
NOTE You cannot resume a stopped patrol read.
NOTE You can run this command only when a patrol read operation is running on the controller.