Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 37)

LSI Corporation
- 37 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Virtual Drives Commands
4.4.8 Virtual Drive Migration Commands
The Storage Command Line Tool supports the following commands for virtual drive migration (reconstruction):
storcli /cx/vx show migrate
storcli /cx/vx start migrate raidlevel>
[option= disk= ]
The detailed description for each command follows.
storcli /cx/vx show migrate
This command shows the progress of the virtual drive migrate operation in percentage.
Input example:
storcli /c0/v0 show migrate
storcli /cx/vx start migrate raidlevel> [option= disk= ]
This command starts the reconstruction on a virtual drive to the specified RAID level by adding or removing disks
from the existing virtual drive. You can use the following options with the start migrate command:
Virtual drive migration can be done between the following RAID levels.
NOTE The virtual drive migration commands are not supported in Embedded MegaRAID.
Table 16 Virtual Drive Migration Command Options
Options Value Range Description
type = RAID level RAID [0|1|5|6] The RAID level to which the virtual drive must be
migrated.
[option=
disk=] add : Adds disks to the virtual drive and starts
reconstruction.
remove : Removes disks from the virtual drive and starts
reconstruction.
disk : The enclosure number and the slot number of the
disks to be added to the virtual drive.
Adds or removes disks from the virtual drive.
Table 17 Virtual Drive Migration Table
Initial RAID level Migrated RAID level
RAID 0 RAID 1
RAID 0 RAID 5
RAID 0 RAID 6
RAID 1 RAID 0
RAID 1 RAID 5
RAID 1 RAID 6
RAID 5 RAID 0
RAID 5 RAID 6
RAID 6 RAID 0
RAID 6 RAID 5