Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 48)

LSI Corporation
- 48 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Logging Commands
storcli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
This command sets the PHY link speed. You can set the speed to 1.5 Gb/s, 3 Gb/s, 6 Gb/s, or 12 Gb/s. The linkspeed is
set to auto when you specify linkspeed = 0.
Input example:
storcli /c0/p0 set linkspeed=1.5
storcli /cx/px|pall show
This command shows the basic PHY layer information.
Input example:
storcli /c1/p0 show
storcli /cx/px|pall show all
This command shows all the PHY layer information.
Input example:
storcli /c1/p0 show all
4.12 Logging Commands
The Storage Command Line Tool supports the following commands to generate and maintain log files:
storcli /cx clear events
storcli /cx delete termlog
storcli /cx show events file=<absolute path>
storcli /cx show eventloginfo
storcli /cx show termlog type=config|contents
The detailed description for each command follows.
storcli /cx delete events
This command deletes all records in the event log.
Input example:
storcli /c0 delete events
storcli /cx delete termlog
This command clears the TTY (firmware log for issue troubleshooting) logs.
Input example:
storcli /c0 delete termlog
storcli /cx show events file=<absolute path>
This command prints the system log to a text file and saves the file in the specified location.
Input example:
storcli /c0 show events file=C:\Users\brohan\test\eventreports