Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 46)

LSI Corporation
- 46 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
BBU Commands
storcli /cx/bbu set learndelayinterval=<value>
This command sets the learn delay interval for the BBU in hours. The value must be between 0 to 168 hours (7 days).
Input example:
storcli /c0/bbu set learnDelayInterval=30
storcli /cx/bbu set powermode=sleep
This command places the battery in low-power storage mode. The battery automatically exits this state after
5 seconds.
Input example:
storcli /c0/bbu set powermode=sleep
storcli /cx/bbu set writeaccess=sealed
This command seals the gas gauge EEPROM write access.
Input example:
storcli /c0/bbu set writeaccess=sealed
storcli /cx/bbu show modes
This command shows the bbu mode information that includes the bbu mode number, retention time, service life,
maximum temperature, and battery learn information.
Input example:
storcli /c0/bbu show modes
storcli /cx/bbu show properties
This command shows the BBU Learn properties for a controller.
Input example:
storcli /c0/bbu show properties
storcli /cx/bbu show status
This command shows the battery information, firmware status, and the gas gauge status.
Input example:
storcli /c0/bbu show status
storcli /cx/bbu start learn
This command starts the BBU learning cycle. The battery learn cycle is immediately started and no other parameters
are required for this command.
Input example:
storcli /c0/bbu start learn
NOTE Use the set writeaccess=sealed command at manufacturing time.