Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 47)

LSI Corporation
- 47 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Enclosure Commands
4.10 Enclosure Commands
The Storage Command Line Tool supports the following enclosure commands:
storcli /cx/ex download src=filepath[forceActivate]
storcli /cx/ex show all
storcli /cx/ex show status
The detailed description for each command follows.
storcli /cx/ex download src=filepath [forceactivate]
This command flashes the firmware with the file specified at the command line. The enclosure performs an error
check after the operation. The following option can be used with the enclosure firmware download command.
Input example:
storcli /c0/e0 download src=c:\file2.bin
storcli /cx/ex show all
This command shows all enclosure information, which includes general enclosure information, enclosure inquiry data,
a count of enclosure elements, and information about the enclosure elements.
Input example:
storcli /c0/e0 show all
storcli /cx/ex show status
This command shows the enclosure status and the status of all the enclosure elements.
Input example:
storcli /c0/e0 show status
4.11 PHY Commands
The Storage Command Line Tool supports the following PHY commands:
storcli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
storcli /cx/px|pall show
storcli /cx/px|pall show all
The detailed description for each command follows.
Table 20 Enclosure Firmware Download Command Options
Option Value Range Description
forceactivate — Issues a command descriptor block (CDB) with write command with no data with command
mode 0x0F (flash download already in progress).
NOTE This option is used primarily to activate Scotch Valley Enclosures.
NOTE The firmware file that is used to flash the enclosure can be of any format. The StorCLI utility assumes
that you provide a valid firmware image.