TA Triumph-Adler P-C2660 MFP - Manual (Page 51)

Preparation before Use
2-9
2
Energy Saver Function
If a certain period of time elapses after the machine is last used, the machine automatically enters Low Power
Mode to reduce power consumption. If a further period of time elapses without the machine being used, the
machine automatically enters sleep mode, which minimizes power consumption.
Low Power Mode
The message display backlight turn off to reduce the
power consumption. This status is referred to as Low
Power Mode.
If print data is received during Low Power Mode, the
machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Low
Power Mode on products with the FAX function
installed, the machine automatically wakes up and
starts printing.
To use the machine, press any key on the operation panel.
The machine will be ready to use within 11 seconds. Note
that ambient environmental conditions, such as ventilation,
may cause the machine to respond more slowly.
For information on the Low Power Mode settings, refer
to Low Power Timer on page 8-149.
NOTE: When a preset time of Low Power Timer and Sleep
Timer is same, Sleep Mode overrides Low Power Mode.
Sleep and Auto Sleep
Sleep
To enter Sleep, press the Energy Saver key. Message
Display and all indicators on the operation panel will go
out to save a maximum amount of power except the
Main Power indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is
performed while the Message Display remains unlit.
If you are using the products equipped with the fax
function, received fax data is printed out while the
operation panel also remains unlit.
There are two sleep modes (models except for
Europe): Quick Recovery and Energy Saver. The
default setting is Energy Saver mode.
NOTE: When a preset time of Low Power Timer and Sleep
Timer is same, Sleep Mode overrides Low Power Mode.