TA Triumph-Adler P-C2660 MFP - Manual (Page 485)

Troubleshooting
10-5
10
Printouts have black
lines. Is the slit glass dirty? Clean the slit glass. 9-2
— Run [LaserScanner Cln]. 8-135
— Run [Drum Refresh]. 8-136
Grey background — Conduct color calibration either by
switching the machine off then on
or using the operation panel. 8-126
Dirt on the top edge or
back of the paper Is the paper transfer unit
dirty? Clean the transfer unit. 9-3
Offset occures. — Run [Drum Refresh]. 8-136
— Run [MC] and increase the
adjustment value. Increase the
adjustment value 1 level at a time
from the current value. If there is
no improvement after the value is
increased by 1 level, increase by 1
level again. If there is still no
improvement, return the setting to
the original value. 8-138
Part of the image is
periodically faint or
blurred. — Run [MC] and decrease the
adjustment value. Decrease the
adjustment value 1 level at a time
from the current value. If there is
no improvement after the value is
decreased by 1 level, decrease by
1 level again. If there is still no
improvement, return the setting to
the original value. 8-138
Symptom Checkpoints Corrective Actions
Reference
Page