TA Triumph-Adler P-C2660 MFP - Manual (Page 490)

Troubleshooting
10-10
Memory is full.
Job is canceled.
– Unable to continue the job as the
memory is used up. Press the OK
key. To print the same originals,
follow the operations below.
• Select [Photo] for the quality of
copies.
• Select a nagative value for the
sharpness.
• Select the paper size smaller to
reduce.
If it is not resolved, expand the printer
memory.
—
Paper jammed. – If a paper jam occurs, the machine
will stop and the location of the jam
will be indicated on the Message
Display. Leave the machine on and
follow the instruction to remove the
jammed paper. 10-16
Job not stored.
Press [OK]. – Press the OK key to cancel storing.
USB memory error.
Job is canceled. – This job is canceled. Press the OK
key. —
Place original
and press Start key. – Remove originals from the document
processor, put them back in their
original order, and place them again.
Press the Start key to resume
printing.
Press the Status/Job Cancel key
and press [Cancel] to cancel the job. 2-67
Remove original from
document processor. Are there any originals left in
the document processor? Remove originals from the document
processor. —
Maximum Number of
scanned pages.
Job is canceled. – Scanning cannot be performed due
to insufficient memory of scanner.
The job is canceled. Press the OK
key. —
Is the acceptable scanning
count exceeded? Press the OK key to print, send or
store the scanned pages. Press the
Status/Job Cancel key and press
[Cancel] to cancel the job. —
Error occurred.
Turn the main power
switch off and on. – System error has occurred. Turn the
main power switch off and on. —
Incorrect account ID. – The Account ID does not match.
Check the registered Account ID. —
Error Message Checkpoints Corrective Actions
Reference
Page