TA Triumph-Adler P-C2660 MFP User Manual
Page 109
Preparation before Use
2-67
2
How to Load Originals
IMPORTANT:
Before loading originals, be sure that there are no originals left on the original eject table.
Originals left on the original eject table may cause the new originals to jam.
1
Adjust the original width guides to fit the originals.
2
Place the originals. Put the side to be scanned (or
the first side of two-sided originals) face-up. Slide
the leading edge into the document processor as
far as it will go.
IMPORTANT:
Confirm that the original width guides
exactly fit the originals. If there is a gap, readjust the
original width guides. The gap may cause the originals
to jam.
Ensure that loaded originals do not exceed the
level indicator. Exceeding the maximum level may
cause the originals to jam (see the figure).
Originals with punched holes or perforated lines
should be placed in such a way that the holes or
perforations will be scanned last (not first).
NOTE:
When the original has been inserted to the
correct position, an automatic document feeder image
will appear in the message display.