TA Triumph-Adler DC 2435 - Manual (Page 45)

FAX Operation (Basic)
3-5
3
document processor starts. When multiple-page originals are placed, each page is scanned after the previous
one is sent.
Direct Transmission (When originals are placed on the glass surface):
This method is suitable for sending book originals that cannot be placed in the document processor. After the
telephone line has connected with the receiving system, the originals placed on the glass surface are scanned
and sent.
NOTE: When continuous scan is set, you can continue with scanning of a next original after an original on the
glass surface has been sent. Every time one page is scanned, you perform an operation to allow continued
scanning.
To select direct transmission, use the following
procedure.
1 Press [Advanced Setup], and then [FAX Direct
Transmission].
2 Press [On].
3 Press [OK].
You can also select the transmission method on the
basic FAX screen. In the basic screen for FAX, press
[Direct].
This selects the direct transmission method and the
keys on the touch panel are highlighted.
Press the highlighted [Direct] key to change the
transmission method to memory transmission.
Destination
Zoom Centering Border Erase FAX Delayed
Transmission
Continuous
Scan
Job Finish
Notice
File Name
Entry
FAX Direct
Transmission
FAX
Polling RX
Send and
Print
10/10/2010 Status
Org./Sending
Data Format
Quick Setup Destination Image Quality Advanced
Setup
Program
Send and
Store
Preview
100%
A4
A4
Preview
Original
Zoom :
:
:
Sending Image
Send
Status 10/10/2010 10:10
ABCD [email protected]
Address
Book
FAX No.
Entry
No.
1/100
AAA BBB CCC DDD
FFF GGG HHH III JJJ
0004 0003 0005 0001 0002
0006 0007 0008 0009 0010
Check
Destinations
Destination
Pause Backspace
EEE
Space
Detail Delete Recall Chain Direct On Hook
Org./Sending
Data Format
Quick Setup Destination Image Quality Advanced
Setup
Program
Enter Destination.