TA Triumph-Adler DC 2435 - Manual (Page 101)

FAX Operation (Advanced)
4-33
4
Forward Settings
FAX/i-FAX > Common > RX/Forward Requirements > General
Specify the forward settings.
The settings available on the Forward page are shown below.
After completing the settings, click Submit to save the settings.
Forward Settings
FAX/i-FAX > Common > RX/Forward Requirements > Requirement List > Add
Specify the Requirement List settings.
The settings available on the Requirement List -Add page are shown below.
Item Description
Off Disables the forwarding process. Received faxes are
printed on paper as in normal operation.
Use Requirements List Executes the forwarding process according to the
specified conditions. (For the setting procedure, refer to
Print Settings on page 4-34.)
All Executes the forwarding process without specifying
conditions. All received faxes are processed in the same
way. However, the process of saving them in a FAX box
cannot be selected. (For the setting procedure, refer to
Print Settings on page 4-34.)
Item Description
Requirement Number Enter a number that identifies the condition set.
Name Give the condition set here an easily recognizable name.
Status Specify whether to enable or disable the condition.
Activating Time Specifies whether a time is specified.
Enable Time Registers times when the specified requirements are
enabled or disabled. You can register any time between
00:00 and 23:59.
File Name Sets the name of the file created when a fax is forwarded.
Additional Information Appends information such as the date/time, job number
and destination address to the file name.
Add Sender Information Sets the position appended in the additional information.
The additional information consists of the local FAX
number for a FAX transmission and the e-mail address of
this machine in the case of an i-FAX transmission.