TA Triumph-Adler DC 2435 - Manual (Page 196)

Internet Faxing (i-FAX) (Option)
8-4
Full Mode
This machine supports full-mode Internet faxing that conforms to the ITU-T T.37 recommendations. If the other
party’s machine also supports full mode, you can use transmission confirmation when you send a fax to check
that it successfully reached the recipient’s machine.
When this machine receives an i-FAX
The machine sends reception capacity information in response to a transmission confirmation request from the
sender. Information on the resolutions, compression modes and paper sizes supported by this machine is sent
to the sender.
When this machine sends an i-FAX
The machine sends a transmission confirmation to recipients who selected full mode. Transmission confirmation
results sent back by recipients are included in the sent fax report.
For more information on sent fax reports, refer to Activity Report on page 5-8.
For more information on setting the conditions for destination machines, refer to Contact Registration (i-FAX) on
page 2-8 or i-FAX Transmission on page 8-8.
i-FAX Settings
To send and receive Internet faxes, you must first specify the SMTP server and POP3 server settings.
Specify these settings using Embedded Web Server RX on a computer that is connected to this machine via a
network.
Refer to the machine’s Operation Guide for information on the network settings.
Accessing (PEHGGHG:HE6HUYHU RX
1 Open the web browser.
2 In the Address or Location bar, enter the machine’s
IP address as the URL, e.g. http://192.168.48.21/.
The web page displays basic information about the
machine and
Embedded Web Server RX as well as the
current status of the machine.