TA Triumph-Adler DC 2435 - Manual (Page 123)

FAX Operation (Advanced)
4-55
4
Using Polling Reception with Sub Addresses
For polling reception, enter the sub address (on this machine, sub address and sub address password) set at
the sending machine. This communication is still possible when the other party is using a third-party machine
provided it is equipped with the same type of sub address communication function.
IMPORTANT: Check the sub address set by the sender beforehand.
1 Press the FAX key.
2 Press [Advanced Setup], and then [FAX Polling RX].
3 Press [On].
4 Press [OK].
5 Select the destination. Here, refer to Sub Address
Transmission on page 4-45 when entering the sub
address.
• If Entry Check for New Destination is Off, press
[OK] to complete entering the number.
• If Entry Check for New Destination is On, press
[OK] and you are prompted to confirm the FAX
number is correct. Re-enter the same FAX number
and press [OK] to complete the entry.
• When [New Destination Entry] is set to [Prohibit], the
numeric keys cannot be used to enter a fax number.
For details, refer to Sending faxed documents to a
specified additional address on page 4-63.
For details, refer to Entry Check for New
Destination in the machine’s Operation Guide.
To continue entering a new number, press [FAX No.
Entry] and repeat the above procedure.
To correct the FAX number, press [Edit].
NOTE: Only fax numbers can be selected as destinations.
You can select destinations using a combination of numeric
keys input, One-touch keys selection and selection from the
Address Book containing registered sub addresses.
6 Press the Start key. The operations for reception
begin.
NOTE: When On is selected in Destination Check
before Send, a destination confirmation screen is
displayed when you press the Start key. For details, refer
to Confirmation Screen of Destinations on page 5-12.