2 cleaning and replacing the fans, 1 accessing the fans – KACO Powador XP100-HV User Manual
Page 50

Page 50
Operating Instructions Powador XP100-HV
M a i n t e n a n c e / C l e a n i n g
M a i n t e n a n c e / C l e a n i n g
7.2
Cleaning and replacing the fans
The inverter is equipped with four fans. All of them are located at the top of the housing. Two of the fans are
installed in the left side of the housing to provide ventilation for the power electronics building block. The fan
in the right side of the housing is used to ventilate the housing. The fans must be cleaned on a regular basis to
ensure maximum performance. If there are any problems with the fans, repair or replace them.
7.2.1
Accessing the fans
Switch off the inverter (see page 49)
Clean the fans
Remove the upper covers from the inverter.
Clean the fans.
Attach the upper covers.
Change the fans
Remove the upper covers from the inverter.
Disconnect the plug.
Replace the fan.
When you install a new fan, pay attention to the air fl ow direction (arrow on the fan housing).
Attach the upper covers.
Switch on the inverter (see page 49)
Figure 41: Upper cover on the inverter
Figure 42: Plug for the in the right side of the
housing
Figure 43: Fans used for the power electronics
building block
Figure 44: In front of fans