KACO Powador XP100-HV - Manual (Page 40)

Page 40 Operating Instructions Powador XP100-HV
F a u l t s a n d W a r n i n g s
6 Faults and Warnings
When a problem occurs in the system, the Inverter will beep and inform the user on the GUI. The Inverter displays
two basic error messages. The fi rst, the fault, is a serious problem that causes the inverter to stop running. The
second, a warning, is a minor problem that does not cease the system operation. The GUI will indicate faults in red
and warnings in yellow. The user can fi nd a description of the diff erent fault and warnings in the following Tables.
6.1 Warnings
Code Message Description
81 SP1 (PV SP) Failure Failure of the PV side surge protector (SP1)
82 CB10 (PV Contactor) Failure PV side contactor (CB10) failure
83 PV Fuse Failure PV side Fuse failure (option)
84 Ground Fault Warning The insulation resistance of the PV falls short of the limit set in the ground
fault monitoring for Alert1 (option)
85 PV Over Voltage PV voltage exceeds the parameter [DC over voltage Level]
100 PEBB Over Temp. Warning The temperature of the PEBB (Power Electronics Building Block) heatsink
exceeds 75°C (167°C)
101 PEBB Fan Failure Failure of a PEBB (Power Electronics Building Block) fan
110 SP2 (Grid SP) Failure Failure of the grid side surge protector (SP2)
120 Test Mode The system is working in test mode
121 Watchdog Abnormalities detection in the DSP
125 Parameter Invalid Parameter is invalid value
130 Cabinet Over Temp.
Warning The temperature of the cabinet exceeds the operational parameter [Cab-
inet Temperature Maximum]
131 Cabinet Under Temp.
Warning The temperature of the cabinet falls below the operational parameter
[Cabinet Temperature Minimum]
134 Control SMPS Failure Failure of the control SMPS (Switching Mode Power Supply)
Table 5: Warnings