HEIDENHAIN TNC 426 (280 476) - Manual (Page 487)

460 13 Tables and Overviews
13.1 Gener
a
l User P
a
ra
met
e
rs
Error message during cycle call MP7441
Error message when M3/M4 not active: 0
Suppress error message when M3/M4 not active: +1
reserved: +2
Suppress error message when positive depth programmed: +0
Output error message when negative depth programmed: +4
M function for spindle orientation in the
fixed cycles MP7442
Function inactive: 0
Orientation directly through the NC: -1
M function for orienting the spindle: 1 to 999
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements MP7471
0 to 99 999 [mm/min]
Datums from a datum table are referenced
to the MP7475
Workpiece datum: 0
Machine datum: 1
Running pallet tables MP7683
Program Run, Single Block: Run one line of the active NC program at every
NC start; Program Run, Full Sequence: Run the entire NC program at
every NC start: +0
Program Run, Single Block: Run the entire NC program at every NC
start:+1
Program Run, Full Sequence: Run all NC programs up to the next pallet at
every NC start: +2
Program Run, Full Sequence: Run the entire NC pallet file at every NC
start:+4
Program Run, Full Sequence: If running of the complete pallet file is
selected (+4), then run the pallet file without interruption, i.e. until you
press NC stop: +8
Pallet tables can be edited with the EDIT PALLET soft key: +16
Display the AUTOSTART soft key: +32
Pallet table or NC program is displayed: +64
Machining and program run