HEIDENHAIN TNC 426 (280 476) User Manual
Page 271
244
8 Programming: Cycles
8.3 Cy
cles f
o
r Dr
illing, T
a
pping and Thr
ead Milling
7
7
7
7
Nominal diameter
Q335: Nominal thread diameter
7
7
7
7
Thread pitch
Q239: Pitch of the thread. The algebraic
sign differentiates between right-hand and left-hand
threads:
+= right-hand thread
– = left-hand thread
7
7
7
7
Thread depth
Q201 (incremental value): Distance
between workpiece surface and root of thread
7
7
7
7
Total hole depth
Q356 (incremental value): Distance
between workpiece surface and bottom of hole
7
7
7
7
Feed rate for pre-positioning
Q253: Traversing
speed of the tool when moving in and out of the
workpiece, in mm/min
7
7
7
7
Climb or up-cut
Q351: Type of milling operation with
M03
+1 = climb milling
–1 = up-cut milling
7
7
7
7
Plunging depth
Q202 (incremental value): Infeed per
cut. The depth does not have to be a multiple of the
plunging depth. The TNC will go to depth in one
movement if:
n
the plunging depth is equal to the depth
n
the plunging depth is greater than the depth
7
7
7
7
Upper advanced stop distance
Q258 (incremental
value): Set-up clearance for rapid traverse positioning
when the TNC moves the tool again to the current
plunging depth after retraction from the hole
7
7
7
7
Infeed depth for chip breaking
Q257 (incremental
value): Depth at which TNC carries out chip breaking.
There is no chip breaking if 0 is entered.
7
7
7
7
Retraction rate for chip breaking
Q256
(incremental value): Value by which the TNC retracts
the tool during chip breaking
7
7
7
7
Depth at front
Q358 (incremental value): Distance
between tool point and the top surface of the
workpiece for countersinking at the front of the tool
7
7
7
7
Countersinking offset at front
Q359 (incremental
value): Distance by which the TNC moves the tool
center away from the hole center