HEIDENHAIN TNC 426 (280 476) - Manual (Page 283)

256 8 Programming: Cycles
8.3 Cy
cles f
o
r Dr
illing, T
a
pping and Thr
ead Milling
14 LBL 1 Subprogram 1: Thread cutting
15 CYCL DEF 13.0 ORIENTATION Define the spindle angle (makes it possible to cut repeatedly)
16 CYCL DEF 13.1 ANGLE 0
17 L M19 Orient the spindle (machine-specific M function)
18 L IX-2 R0 F1000 Tool offset to prevent collision during tool infeed (dependent
on core diameter and tool)
19 L Z+5 R0 F MAX Pre-position in rapid traverse
20 L Z-30 R0 F1000 Move to starting depth
21 L IX+2 Reset the tool to hole center
22 CYCL CALL Call Cycle 18
23 L Z+5 R0 F MAX Retract tool
24 LBL 0 End of subprogram 1
25 END PGM C18 MM