8 adding comments, Function, Entering comments during programming – HEIDENHAIN TNC 426 (280 476) User Manual
Page 100: Inserting comments after program entry, Entering a comment in a separate block, 8 a dding comments 4.8 adding comments
HEIDENHAIN TNC 426, TNC 430
73
4.8 A
dding Comments
4.8 Adding Comments
Function
You can add comments to any desired block in the part program to
explain program steps or make general notes. There are three
possibilities to add comments:
Entering comments during programming
7
7
7
7
Enter the data for a program block, then press the semicolon key “;”
on the alphabetic keyboard—the TNC displays the dialog prompt
COMMENT?
7
7
7
7
Enter your comment and conclude the block by pressing the END
key.
Inserting comments after program entry
7
7
7
7
Select the block to which a comment is to be added.
7
7
7
7
Select the last word in the block with the right arrow key:
A semicolon appears at the end of the block and the TNC displays
the dialog prompt COMMENT?
7
7
7
7
Enter your comment and conclude the block by pressing the END
key.
Entering a comment in a separate block
7
7
7
7
Select the block after which the comment is to be inserted.
7
7
7
7
Initiate the programming dialog with the semicolon key “;” on the
alphabetic keyboard.
7
7
7
7
Enter your comment and conclude the block by pressing the END
key.