HEIDENHAIN TNC 426 (280 476) - Manual (Page 34)

8 1 Introduction
1
.3 Modes of Oper
ation
Program Run, Full Sequence and Program Run,
Single Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual or
programmed stop. You can resume program run after an interruption.
In the Program Run, Single Block mode of operation you execute each
block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Soft keys for selecting the screen layout for pallet tables
Screen windows Soft key
Program
Left: program blocks, right: program structure
Left: program. Right: status
Left: program. Right: graphics
Graphics
Screen windows Soft key
Pallet table
Left: program. Right: pallet table
Left: pallet table. Right: status
Left: pallet table. Right: graphics