HEIDENHAIN TNC 306 Service Manual - Manual (Page 98)

SERVICE MANUAL TNC 306/360
Page 91
HEIDENHAIN Service
TNC Dialog Display
Press
Key Remarks
LIMIT X+ =
.
Note down the limit values
LIMIT X- = .
(Do not forget the algebraic
signs!)
LIMIT Y+ = .
LIMIT Y- = .
LIMIT Z+ = .
LIMIT Z- = .
LIMIT IV+ = .
LIMIT IV- = .
NC: SOFTWARE-NUMBER
PLC: SOFTWARE-
NUMBER
END
19.1.6 Labelling the Connecting Cables:
If the connecting cables are labelled incompletely or not at all, they have to be marked such
that the correct plug connections can be re-established after the exchange of the LOGIC UNIT
or of another assembly.
Pin layout: see section 6
*
Warning!
Switching the connecting cables may destroy the unit!