HEIDENHAIN TNC 306 Service Manual - Manual (Page 6)

SERVICE MANUAL TNC 306/360
Page 4
HEIDENHAIN Service
2. Minor Error Messages
The TNC 306/360 features a comprehensive integrated monitoring system to avoid input or
operation errors, to locate errors and technical defects of the entire equimpent (TNC,
measuring system, machine tool, cables etc). The monitoring system is a fixed component
of the TNC hardware and software; it is always active when the control is switched on. If a
technical defect or an operation error is detected, an error message in plain language is
displayed on the screen.
To erase minor error messages, press
CE
.
Further error messages are described in the Operating Manual TNC 306 and TNC
360, in the Technical Manual, in the Documentation by the machine tool
manufacturer or in the Operating Instructions FE 401 B.
Error Message Sec. Error Message Sec.
AXIS DOUBLE PROGRAMMED 13.2 ERR: 105 12.6
START POSITION INCORRECT 13.2 ERR: 106 12.6
TOUCH POINT INACCESSIBLE 13.2 ERR: 107 12.6
RANGE EXCEEDED 13.2 ERR: 108 12.6
OPERATING PARAMETER ERASED 2.1 EMERGENCY STOP 17.4
CYCL-PARAMETER INCORRECT 13.2 EXT. IN-/OUTPUT NOT READY 14.6
FAULTY RANGE DATA 13.2 WRONG AXIS PROGRAMMED 13.2
ROTATION NOT PERMITTED 13.2 WRONG PROGRAM DATA 14.6
PLANE WRONGLY DEFINED 13.2 SCALING FACTOR NOT PERMITTED 13.2
ENTRY VALUE INCORRECT 14 PLC: PROGRAM MEMORY ERASED 15.1
LIMIT SWITCH 2.1 POSITIONING ERROR 2.1
ERR: 001 12.6 PROGRAM MEMORY EXCEEDED 15.1
ERR: 002 12.6 EXCHANGE BUFFER BATTERY 8.6
ERR: 003 12.6 MIRRORING NOT PERMITTED 13.2
ERR: 004 12.6 RELAY EXT. DC VOLTAGE MISSING 17.4
ERR: 010 12.6 POWER INTERRUPTED 2.1
ERR: 012 12.6 EXCHANGE TOUCH PROBE BATTERY 13.2
ERR: 013 12.6 STYLUS ALREADY IN CONTACT 13.2
ERR: 014 12.6 PROBE SYSTEM NOT READY 13.2
ERR: 100 12.6 TRANSFERRED VALUE ERRONEOUS 14.6
ERR: 102 12.6 TIME LIMIT EXCEEDED 13.2
ERR: 103 12.6
ERR: 104 12.6