HEIDENHAIN TNC 306 Service Manual - Manual (Page 110)

SERVICE MANUAL TNC 306/360
Page 103
HEIDENHAIN Service
20. Machine Parameters
The following list contains the machine parameters of all software versions.
However, as some machine parameters are not valid for certain controls or have
been introduced/eliminated with a certain software version, columns with symbols
for differentiation have been added after the parameter numbers.
Meaning of the Symbols:
♦
= With this control, the machine parameter is valid for all software versions.
04 = The machine parameter has been introduced with a certain software version
(e.g. 04 means introduction with software version 04).
I04 = The machine parameter has been eliminated starting with a certain software
version (e.g. I04 means elimination as of software version 04), or it has
been replaced by another parameter.
- = This machine parameter is not available with this control.
* = The machine parameter is accessible via the code number 123.
Structure
The machine parameters are subdivided into groups.
Due to the structure of the parameter numbers, the list can be expanded easily.
0-999 Encoders and machine tool axes: allocation, evaluation, compensation
1000 Positioning
1400 Operation with feed precontrol
1700 Operation with servo lag
3000 Spindle control
4000 Integrated PLC
5000 Adaptation of the data interface
6000 Measurement with 3D-touch probe system
6200 Digitizing with 3D-touch probe system (only if software enable module
inserted)
7100 Tapping
7200 Display and programming
7320 Colour allocation for colour screens
7330 User-parameters
7400 Processing and program run
7600 Hardware