HEIDENHAIN TNC 306 Service Manual - Manual (Page 70)

SERVICE MANUAL TNC 306/360
Page 63
HEIDENHAIN Service
15.1.3 Calling Directory of all NC Programs (XXX.H) on
External Data Medium
Press key Function
Activate operating mode PROGRAMMING AND EDITING
EXT Prepare TNC for data input
or Select item PROGRAM DIRECTORY
ENT Acitvate selection
All NC programs that are stored on the external data medium are now displayed.
NO
ENT Return to operating mode PROGRAMMING AND EDITING
15.1.4 Downloading all NC Programs
Press key Function
Activate operating mode PROGRAMMING AND EDITING
EXT Prepare TNC for data input
or Select item READ-IN ALL PROGRAMS
ENT Start data transfer
When the data transfer is finished, the dialog EXTERNAL DATA INPUT is cleared
and the control is at the NC program downloaded last.
Change operating mode
Note:
The tool data for the central tool file (MP7260
≠
0) are stored in the
NC program No. 0.