Ext. in-/output not ready, Wrong program data, Entry value incorrect – HEIDENHAIN TNC 306 Service Manual User Manual
Page 65: Transferred value erroneous
SERVICE MANUAL TNC 306/360
Page 58
HEIDENHAIN Service
14.6.2 Error Messages during Data Transfer via the
RS-232C Interface
TRANSFERRED VALUE ERRONEOUS X
X = A Faulty character frame
B Character overflow
C Faulty character frame or character overflow
D Parity error
E Faulty character frame or parity error
F Character overflow or parity error
G Faulty character frame or character overflow or parity error
H Overflow of receiveing buffer
M Control has received the character for "negative acknowledgement" (NAK)
more than 3 times
N Control has sent the character for "negative acknowledgement" (NAK)
more than 3 times
EXT. INPUT/OUTPUT NOT READY
-
DSR signal missing at the TNC
-
FE not connected
-
Defective or wrong transfer cable
WRONG PROGRAM DATA
Wrong program data have been detected during data transfer.
ENTRY VALUE INCORRECT
-
The control requires more machine parameters than are stored on the external data
medium.
-
One or more machine parameters on the external data medium have non-permissible
values.
NOTES