HEIDENHAIN TNC 306 Service Manual - Manual (Page 76)

SERVICE MANUAL TNC 306/360
Page 69
HEIDENHAIN Service
15.2.5 Output of a Tool Table
Machine parameters for the central tool memory
Parameter
No. Entry values
7260 0
→
no central tool file
1 ... 99
→
central tool file
entry value = maximum number of tools in the tool file
If MP 7260 > 0, the control automatically creates a tool table in the NC-PGM 0, according
to the value entered in MP 7260. The tool data this table contains can be output as follows:
Press key Function
Activate operating mode PROGRAMMIN AND EDITING
EXT Prepare TNC for data output
or Select item OUTPUT SELECTED PROGRAM
ENT Activate selection
or Select program number 0
ENT Start output of data
When data transfer is finished, the dialog
EXTERNAL DATA OUTPUT
is cleared.
NO
ENT Return to PROGRAMMING AND EDITING