HEIDENHAIN TNC 306 Service Manual - Manual (Page 72)

SERVICE MANUAL TNC 306/360
Page 65
HEIDENHAIN Service
15.1.7 Downloading the Tool Table
Machine parameters for the central tool file:
Parameter
No. Entry values
7260 0
→
no central tool file
1 ... 99
→
central tool file
entry value = maximum number of tools in the tool file
If MP 7260 > 0, the control automatically creates a tool table in the NC-PGM 0, according
to the value entered in MP 7260. This table can be downloaded as follows:
Press key Function
Activate operating mode PROGRAMMING AND EDITING
EXT Prepare TNC for data input
or Select item READ-IN SELECTED PROGRAM
ENT Activate selection
0
Enter program number 0
ENT Start data transfer
CE
Clear dialog PROGRAM NUMBER ALLOCATED (tool data in
the control are overwritten)
When data transfer is finished, the dialog EXTERNAL DATA INPUT is cleared
and the control is at the tool table.
Change operating mode
Possible Error Messages
WRONG PROGRAM DATA 0/XX
- The current value in MP 7260 is not equal to the value it had when the tool table was
read out.
ENTRY VALUE INCORRECT
- The entry value of MP 7260 is 0.