HEIDENHAIN TNC 306 Service Manual - Manual (Page 127)

HEIDENHAIN Service
Function MP TNC TNC .NC CNC Input AE-6
No. Bit 2500 360 306 234 Input Value
Sparking-out duration
(minimum free-run duration)
2110 - -
‹
- 0.1 to 99.9 [s] 1
Time for electric arc recognition 2120 - -
‹
- 1 to 99.9 [s] 10
Max. speed for feed precontrol
during gap control
2130 - - 04 - 0 to 3000 [mm/min] 50
Max. permissble feed for eroding 2131 - - 04 - 0 to 3000 [mm/min] 30
Free-run feed during eroding 2132 - - 04 - 0 to 3000 [mm/min] 30
Retraction speed if a short circuit
has occured (only during the
eroding process) via X12 2133 - - 04 - 0 to 3000 [mm/min] 200
Positioning during timing 2190 - - 04 -
0 to 2
0 =
During traverse of the timer distance
the speed is reduced between the
individual blocks
1 = The timer distance is traversed
continuously, if the contour (line/circle) is
geometrically continuous
(recommended setting).
2 = The timer distance is traversed
continuously, even if the contour is
geometrically discontinuous. This causes
an increased load on the driving elements
in corners.
1
General eroding table 2199 - -
‹ ‹
0 = eroding table on
2 = eroding table off 2
R.H. TNC 306/335/360/2500
1.0 CNC 234/306
Machine Parameters MP 2110 - MP 2199 29.06.94 26.2 8.4