HEIDENHAIN TNC 306 Service Manual - Manual (Page 62)

SERVICE MANUAL TNC 306/360
Page 55
HEIDENHAIN Service
14.4 Machine Parameters for the RS-232-C-/
V.24-Interface
The detailed functions of the machine parameters are explained in the TNC-Manual for
Machine Tool Manufacturers and in the information on the data interface RS-232-C-/V.24
In the operating modes ME and FE the interface parameters are fixed. In the EXT
operating mode, the machine parameter values for the data interface that are preset by the
control can be altered.
14.4.1 Machine Parameters for "Standard Interface"
(e.g. for ME 101, Printer)
MP Function Entry Values
5010.0
5020
5030
Control character for end of program
7 data bits, transfer stop by DC 3
parity bit (even parity), 1 stop bit
Standard data interface 3 = ETX
168
0
14.4.2 Machine Parameters for "Transfer Blockwise"
MP Bit Function Entry Values
5010.0 0...7
8...15
ETX or any ASCII character. Character for end of
program
STX or any ASCII character. Character for
program start
ETX and STX:
515
5010.1 0...7
8...15
H or any ASCII character. Is transferred in the
command block for data input before the
program number.
E or any ASCII character. Is transferred in the
command block for data input after the program
number. H and E:
17736
5010.2 0...7
8...15
H or any ASCII character. Is transferred in the
command block for data input before the
program number.
E or any ASCII character. Is transferred in the
command block for data input after the program
number. H and A:
16712
5010.3 0...7
8...15
ETB or substitute character. Is sent at the end of
the command block.
SOH or substitute character. Is sent at the
beginning of the command block. ETB and SOH:
279
5010.4 0...7
8...15
ACK or substitute character for pos.
acknowledgement. Is transferred, after the data
block was received correctly.
NAK or substitute character for neg.
acknowledgement. Is transferred , if the data
block was received defectively. ACK and NAK:
5382