Epson 386/25 - Manual (Page 94)

Follow these steps to run HDSIT:
1. Exit any program you are using and make sure the MS-DOS
command prompt appears on the screen.
2. If you copied HDSIT to your hard disk (as described at the
beginning of this chapter), type C : and press Enter to log
onto the root directory of the hard disk.
If you do not have a hard disk or you did not copy HDSIT to
drive C, insert the Reference diskette in drive A. Then type
A : and press Enter to log onto that drive.
3. Type the following and press Enter:
HDSIT
You see a message on the screen that tells you the disk drive’s
read/write heads will remain locked until you reset the computer
or turn the power off and on again. The computer locks the
heads and disables the keyboard. Remove any diskettes and turn
off the computer. You are now ready to move it to the new
location.
Note
If your computer came with a 5¼-inch diskette drive and you
still have the original diskette drive protector card, you may
want to insert it into the drive prior to shipping your
computer to protect the read/write heads.
3-24 Using Your Computer