Epson 386/25 User Manual

Page 220

Remove the four screws securing the hard disk drive

mounting plate to the hard disk drive. Then remove and
store the mounting plate along with the screws.

Wrap the hard disk drive in its original packing materials

and set it aside. Then carefully arrange the power supply
cable so that it fits down into the vertical mounting area.

Make sure that the cable does not interfere with any other

cables or mechanisms.

Follow the steps on page 5-30 to replace the computer’s
cover. Then see “Post-installation Setup” later in Chapter 5

for instructions on configuring your computer for use

without a hard disk drive.

Note
After you change your computer’s drive configuration, your

computer may take up to five minutes to complete power-on

diagnostics the next time you turn it on.

Installing or Removing a Disk Drive in the

Horizontal Position

This section describes how to install or remove a hard disk drive

or a diskette drive in the lower horizontal drive bay. You can use

these same instructions if you need to install a different diskette
drive in the upper drive bay; however, the illustrations show the

lower bay.

If you are installing a second hard disk or diskette drive, you

must install it in the lower horizontal drive bay. Your first

diskette drive is in the upper bay and your first hard disk is in

the vertical mounting position beside the drive bays.

Installing and Removing

Disk Drives

B-27