Epson 386/25 - Manual (Page 168)

Running AutoCAD
Prior to starting an AutoCAD or AutoShade session, you must
load the display driver into the computer’s memory. Follow
these steps:
1. If necessary, log onto your AutoCAD directory.
2. Type the following and press Enter:
FASTACAD
This command runs the FASTACAD.BAT batch file,
which loads the display driver into your computer’s memory.
3. Then start AutoCAD or AutoShade. (The first time you use
AutoCAD or AutoShade with the new driver, follow the
instructions in the sections below to configure the programs
for an ADI display.)
4. When you are finished using the programs, type the
following and press Enter to remove the display driver from
memory:
DLDVGA -U
Configuring AutoCAD
The first time you use AutoCAD with the driver, you need to
configure it for an ADI display.
1. Select Configure AutoCAD from the AutoCAD main
menu.
2. After you see the current configuration (if any), select
Configure video display.
A-26 Using the VGA Utilities