Epson 386/25 - Manual (Page 130)

10. Follow the steps on page 5-30 to replace the computer’s
cover. Then see “Post-installation Setup” (following that
section) for instructions on configuring your computer for
use with your new memory.
Removing Memory Modules
If you need to remove memory modules from your computer,
have your dealer do it for you or follow the steps below. If you
remove them yourself, check the table on page 5-17 to be sure
you remove SIMMs from the correct sockets.
Caution
It is safer to have your dealer remove SIMMs for you since
there is a danger of transmitting an electrostatic discharge
and damaging your components.
1. Remove the cover. See page 5-2 for instructions.
2. Turn the computer so the back panel faces left and the front
panel faces right. The SIMM sockets are located on the
main system board above the option slots, as shown below.
5-22
Installing and Removing
Options