Epson 386/25 User Manual
Page 159
When Setup asks for the name of the drive and directory to
contain the driver files, erase the default name and enter the
directory containing your
AutoCAD 2.62
program files.
2.
Before
running AutoCAD, you must load the display driver
into the computer’s memory. First, log onto your AutoCAD
directory.
Then type the display driver filename at the MS-
DOS command prompt and press
Enter.
(The display driver
filenames are listed at the beginning of this section.) For
example, to load the 1024 x 768, 16-color graphics driver
into memory, type the following and press
Enter:
D2V1768
Installing the driver in the
AUTOEXEC.BAT
file
You can install the driver automatically each time you turn on
or reset your computer by placing the command in your
AUTOEXECBAT file. Follow these steps:
1.
Type
C
: \ and press
Enter
to log onto the root directory of
your hard disk.
2.
Type the following and press
Enter:
COPY AUTOEXEC.BAT+CON AUTOEXEC.BAT
3.
Type the driver name (such as
D2V17
68) and press
Enter.
4.
Press F6 and then Enter.
Configuring AutoCAD
The first time you use AutoCAD with the driver, you need to
configure it for an ADI display. Follow the steps below:
1. Select
Configure AutoCAD
from the AutoCAD
main menu.
Using the VGA Utilities
A-17