Epson 386/25 - Manual (Page 40)

Automatic Configuration
The Equity 386/25 PLUS automatically defines your system’s
memory configuration and recognizes a math coprocessor, if you
have installed one. It also detects and configures most of the
devices you have installed in your system. For this reason, you
may not need to change any of the default settings in the Setup
program. However, you should check each of the options on the
Setup menu to verify that the settings are correct for your
configuration.
The computer automatically configures the 2MB of memory that
comes with your system as 640KB of base memory and 1024KB
of extended memory. If you install even more memory, Setup
configures it as extended memory also.
Starting the Setup Program
Follow these steps to start the Setup program:
1. Make sure your computer is turned off.
2. Insert the Reference diskette in drive A as shown in the
following illustration. Make sure the label is facing up and
the read/write slot is pointed toward the drive.
2-2 Running the Setup Program