Epson 386/25 - Manual (Page 61)

The same parameter is highlighted on the submenu above.
Enter the correct number of cylinders and press Enter.
The information for Number of cylinders is
automatically updated on the submenu above and you see
the next parameter,
Number of heads. Enter the
correct number of read/write heads for the hard disk and
press
Enter.
Follow this same procedure for each remaining item in the
settings list (the number of sectors, the precompensation
cylinder, and the landing zone).
If you enter a parameter incorrectly, press or to
highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total
storage capacity; it calculates the storage capacity for you
based on what you enter for the number of cylinders, heads,
and sectors.
After you type the landing zone number and press Enter,
the cursor block returns to the Drive submenu heading.
8. If you want to change the hard disk type for another drive,
press or and return to step 4.
9. When the hard disk drive settings are correct, press to
move the cursor block into the top submenu. Highlight
** SAVE SETTINGS * * and press Enter to save your
hard disk drive configuration.
Running the Setup Program
2-23