Epson 386/25 - Manual (Page 206)

Adding SNOOZE to the AUTOEXEC.BAT file
For convenience in accessing SNOOZE, you can include a
pathname in your AUTOEXEC.BAT file. Follow these steps:
1. At the MS-DOS command prompt in the root directory,
type the following and press Enter:
COPY AUTOEXEC.BAT+CON AUTOEXEC.BAT
To set the path for the SNOOZE utility, type the following
and press Enter:
PA
TH C:\pathname\
For instance, if you were using the default directory offered
by the VGA Driver Setup program (described above), you
would type:
PATH C:\UTIL\
3. Press F6 and then Enter.
Using the utility
To activate the utility, type SNOOZE and press Enter. You see
information about the SNOOZE command syntax and a
message that the SNOOZE delay is set to 5 minutes.
The default period of inactivity before the screen goes blank is
5 minutes. You can specify your own time period by entering a
number from 1 to 60 (minutes) on the SNOOZE command line.
For example, to set a SNOOZE delay of 15 minutes, type the
following and press Enter:
SNOOZE 15
To disable SNOOZE, type SNOOZE 0 and press Enter.
A-64 Using the VGA Utilities