beautypg.com

Post-installation setup – Epson 386/25 User Manual

Page 140

background image

5.

Reconnect the computer to the monitor, printer, keyboard,

and any other peripherals you have.

6. Reconnect the power cable to the back of the computer and

to an electrical outlet.

Post-installation Setup

After you install or remove a math coprocessor or memory

modules, you need to run the Setup program on your Reference
diskette so it can automatically update the computer’s
configuration information. If you install or remove any other

type of option, such as an option card or a disk drive, you must

run Setup to update your settings. For example, if you add a hard
disk drive, you need to let the computer know the type of drive
you have installed. See Chapter 2 for instructions.

Note

If you installed additional extended memory and want to use

any of it as expanded memory, see “Using Expanded Memory

Beyond 64OKB” in Chapter 4 for more information.

If you install a hard disk drive that has never received a

hardware level format (such as some non-Epson hard disk
drives), you need to format the disk. Check the manual that

came with your drive, and then, if necessary, follow the

instructions in Appendix C to format your new hard disk.

If you have added a hard disk drive and you want to load

MS-DOS or another operating system from that drive, you need

to install the operating system on it. See your MS-DOS

Installation Guide or the documentation that came with your

operating system for instructions.

If you install a memory option card, use the setup program that
came with it to configure the computer for use with the card.
See your memory card manual for instructions.

5-32

Installing and Removing Options