beautypg.com

Leaving the setup menu – Epson 386/25 User Manual

Page 69

background image

Check each Setup summary screen to see if all the information is

correct. You can press

PgUp

to display the previous screen or

PgDn

to display the next screen. If anything is incorrect, be sure

Change

settings

is highlighted and press

Enter.

The

main Setup menu appears and you can change the appropriate
settings.

Leaving the Setup Menu

If you did not change any settings or you want to cancel the
changes you made, highlight

Exit

without saving at

a Setup summary screen and press

Enter.

The Operation Menu

appears. (If you changed the time or date, the new setting takes
effect even if you exit the Setup program without saving your
changes.)

If you want to save the settings you entered, highlight

** EXIT AND SAVE

* *

and press

Enter

at a Setup

summary screen. The Setup program stores the new settings and
resets the computer using the new configuration. If you have set
a password, you need to enter it at the key prompt. (See “Using
a Power-on Password” in Chapter 3 for instructions.) The

Operation Menu appears.

If you have just run Setup for the first time, remove the

Reference diskette from the drive and turn off your system. Then

follow the instructions in your MS-DOS Installation Guide to

install MS-DOS. (If you are using a different operating system,

follow the installation instructions in that manual.)

Once you have installed MS-DOS, you should always boot the
computer from the hard disk or the MS-DOS Startup diskette
when you are finished running Setup. First remove the

Reference diskette from drive A. If you do not have a hard disk,

insert the Startup diskette. Then reset your computer to make

sure it performs all the commands in the CONFIG.SYS and

AUTOEXEC.BAT files.

Running the Setup Program.

2-31