Epson 386/25 User Manual

Page 232

Position

power

supply connector P4 so the large tab on the

connector faces the right side of the computer. Beginning
with the six pins toward the back of the computer, carefully

line up the holes in the connector with the pins in the

socket. Make sure the holes fit over all six pins and then
push the connector onto the pins.

Caution

If you do not correctly align

the holes with the

pins in the

socket, you could severely damage your computer when
you push in the connector.

Connect power supply connector P5 to the remaining six
pins in the socket using the same procedure.

Still holding up the subassembly, locate the hard disk drive
and diskette drive ribbon cables. (The hard disk drive cable

is slightly longer than the diskette drive cable.) Look at the

back of each drive to make sure you know which cable is
which.

Installing and Removing Disk Drives

B-51