Grass Valley Newton Modular Control System v.2.0 - Manual (Page 92)

92 Newton Instruction Manual
Section 4 — Operation
Monitor Button
The Monitor button enables the Newton Control Panel router following and
monitoring mode. In this mode, the Newton Control Panel follows the
router source selection made on the configured Monitored Destination
when a setup has been associated with a router source in Newton Panel
Configurator.
In this example, a setup made in Newton Panel Configurator for the Sat_4
channel shown in
Figure 78 (Brightness_Y Offset) has been associated with
Router Source, SRC_3. With a valid router configuration, when SRC_3 is
taken to the Monitored Destination on the router, the setup will appear on
the configured Newton Control Panel(s). Refer to
Associate Router Source
with Setup on page 61 for configuration details.
Figure 78. Newton Setup Associated with Router Source