Grass Valley Newton Modular Control System v.2.0 - Manual (Page 88)

88 Newton Instruction Manual
Section 4 — Operation
Right click on the fourth knob (Newton PC) or push in the fourth knob on
the rack mount panel to send an all-level take to the router control system
putting the preset source on the selected destination. The display will now
show the current router status as illustrated in
Figure 72 . The preset source
will now show on the current destination.
Figure 72. Router Source Take
Preset Destination Mode
A named router destination may also be selected using the Route button.
(This is not the Monitored Destination, see Note below.) To change destina-
tions, use the third knob (green LED) to switch the display to the Preset
Destination mode as shown in
Figure 73 on page 89 .
The current destination is Dst1. Use the fourth knob to select a different
destination in the PST DST area, such as Dst2 as used in this example, and
right click on NewtonPC or push the knob in on the rack mount panel to
select this destination on the router.
Tally status for the source and destination selected must be determined
from the router panel. Newton cannot report router status when switching
sources or destination in this manner.
Note The destination selected in this mode does not change the Monitored Desti-
nation that has been configured in Router Configuration. Refer to
Preset
Monitored Destination on page 90 for these instructions.
Right click on the fourth knob
the selected preset source
with the yellow LED to assign