Set rack mount network configuration – Grass Valley Newton Modular Control System v.2.0 User Manual
Page 41
Newton Instruction Manual
41
Network and Operating Parameter Configuration
Set Rack Mount Network Configuration
Select the
Panel Network
link on the left of the web page. This will bring up
the Newton Panel Network Configuration web page (
). The
current Ethernet IP, Subnet Mask IP and Gateway IP addresses set on
will be displayed.
Figure 24. Newton Panel Network Configuration Web Page
You can also use this web page to set the IP Addresses of the panel as fol-
lows:
1.
Enter the desired IP addresses to put this device on the same LAN and
subnet as the modules you wish to control.
2.
Check the
Do reset
box if you would like to force the panel to reset upon
saving and resume (reboot) using the new network settings.
3.
Select
Save New Settings
to save the new IP addresses.
4.
Select
Cancel Changes
to cancel any changes made and return to the
previous value.
5.
Select
Factory Defaults
to return all IP values to the factory settings.
Note
Returning to factory default IP Addresses will put the panel on a different
network and may cause loss of communication to the panel.