Preset source select mode, The first press of the – Grass Valley Newton Modular Control System v.2.0 User Manual
Page 87
Newton Instruction Manual
87
Newton Panel Description
Preset Source Select Mode
The first press of the
Route
button brings up the Preset Source select mode.
Preset Source select mode provides the means of taking a source using the
fourth control knob (indicated by a yellow LED) on a Newton panel. In this
mode, the current source on the selected destination is indicated at left as
shown in
for the Newton PC software panel and
for the
rack mount panel.
The Preset Source to be selected is indicated in brackets on the right of the
screen. This example shows SRC11 active on Dst1. Rotate the fourth knob
with the yellow LED (or use the
Plus
and
Minus
buttons on NewtonPC) to
bring another source into the source preset brackets, in this case, SRC20.
Note
The display may report NO STATUS for the source when the router connec-
tion is first established. Use the fourth knob (yellow LED) to select a source,
then also select a destination if required.
Figure 70. Source Select Mode on Newton PC
Figure 71. Source Select Mode on Rack Mount Panel
Fourth knob with yellow LED
Video
In Gain
Video
HTimg
V
Timing
Bright
Y OFF
Learn/
Recall
Enable
Ident
NEWTON
MODULAR CONTROL
8234_00_07
Router
Route
Mon
SRC
DEST
SRC11
Dst1
[ PST SRC ]
[ SRC20 ]
Route button
Fourth knob with yellow LED