Grass Valley Newton Modular Control System v.2.0 - Manual (Page 101)

Newton Instruction Manual 101
Newton Panel Description
Soft Key Monitored Destination Assignment From Control Panel
Use the procedures below to assign a Monitored Destination to a soft key
from the NewtonPC or rack mount control panels.
Note The Monitored Destination can be locked in the Newton Panel Configurator
preventing it from being changed from a panel. To unlock the Monitored Des-
tination, refer to
Router Interface Option Configuration on page 63 .
NewtonPC – Soft Key Monitored Destination Assignments
To make soft key Monitored Destination assignments from the software
panel:
1. Press the Route button to enable the router interface mode.
2. Press the Route button again to bring up the Monitoring Dest mode
( Figure 88 ).
3. Rotate the third knob (yellow LED) or use the Plus and Minus buttons to
select the Monitored Destination (in brackets) you wish to delegate to a
soft key.
Figure 88. Router Preset Monitored Destination Mode
Use third knob with yellow LED
to select preset destination.