Grass Valley Newton Modular Control System v.2.0 - Manual (Page 90)

90 Newton Instruction Manual
Section 4 — Operation
Preset Monitored Destination
To change the Monitored Destination from a panel, press through the Route
button twice to bring up the Monitoring Destination mode shown in
Figure 75 (Newton PC) or Figure 76 (rack mount panel). This example
shows the current Monitored Destination as Dst11.
To change the Monitored Destination, use the third knob (yellow LED) to
enter a preset destination into the Monitoring PST (in brackets). This
example will use Dst12 as shown in
Figure 75 .
If the Monitored Destination has been locked in the Newton Panel Config-
urator, it cannot be changed from the NewtonPC or rack mount panel and
will show a
Monitored Destination is LOCKED message (not shown). To unlock
the Monitored Destination, refer to Router Interface Option Configuration on
page 63 .
Figure 75. Monitored Destination Display on Newton PC
Figure 76. Monitored Destination Display on Rack Mount Panel
Select Monitored Destination preset
with third knob with yellow LED.
Video
In Gain
Video
HTimg
V
Timing
Bright
Y OFF
Learn/
Recall
Enable
Ident NEWTON
MODULAR CONTROL 8234_00_08
Router
Route
Mon
Monitoring DEST:
[ Monitoring PST ]
Dst11
[ Dst12 ]
Select Monitored Destination preset with
third knob with yellow LED.