Grass Valley Newton Modular Control System v.2.0 - Manual (Page 103)

Newton Instruction Manual 103
Newton Panel Description
Rack Mount Panel – Soft Key Router Destination Assignment
To make soft key Monitored Destination assignments from the rack mount
panel:
1. Press the Route button to enable the router interface mode.
2. Press the Route button again to bring up the Monitoring Dest mode
( Figure 90 ).
3. Rotate the third knob (yellow LED) to select the preset Monitored
Destination (in brackets) you wish to delegate to a soft key.
Figure 90. Delegate Soft Key to Monitored Destination at Rack Mount Panel
4. Hold down the Learn/Recall button until the display shows the Press the
soft key to PST router destination message in the display (not shown).
5. Press the desired soft key to assign to this router destination. The
display will return to the Monitoring Destination mode.
6. Select a different Monitored Destination then press the Recall button
and the soft key to verify the correct Monitored Destination is recalled.
Video
In Gain
Video
HTimg
V
Timing
Bright
Y OFF
Learn/
Recall
Enable
Ident NEWTON
MODULAR CONTROL 8234_00_12
Router
Route
Mon
D_DST_2
[D_DST_2]
Monitored Dest:
[ Monitoring PST ]
Dst11
[ Dst12 ]
Route button Learn button Third Knob with Yellow LED