Grass Valley Newton Modular Control System v.2.0 - Manual (Page 35)

Newton Instruction Manual 35
Newton Rack Mount Control Panel Installation
Checking Software Version of Rack Mount Panel
To check the currently loaded software version on the rack mount panel,
hold down the
Ident button. The screen will shown the current software
version and the IP Address of the panel ( Figure 19 ).
Figure 19. Software Version of Rack Mount Panel
Updating Software on Rack Mount Panel With NetConfig
If you have received a CD with a NewtonRM update, use the following
procedure to install updated software to the rack mount control panel:
1. Open NetConfig and select the Load SW icon in the toolbar.
2. The Update Devices window will come up as shown in Figure 20 .
The latest version of NewtonRM rack mount panel software should
appear in the Device Type list.
The Newton rack mount panels accessible on the NetConfig LAN will
appear in the Client Name list along with the software version cur-
rently installed and the IP Addresses of each device.
Figure 20. NetConfig Update Devices Window
Video
In Gain
Video
HTimg
V
Timing
Bright
Y OFF
Learn
Recall
Enable
Ident NEWTON
MODULAR CONTROL
8234_00_1
1 Route
Mon Router
Newton Panel: SW Version 2.0.0
IP Address: 192.168.0.171
Identify button