Grass Valley Newton Modular Control System v.2.0 - Manual (Page 31)

Newton Instruction Manual 31
Newton Control Panel Application Installation
4. A software License Key is required to enable the option. For
NewtonPC, you must first identify the Device ID on the PC on which
you will be using Newton to obtain this code. The Device ID is given on
the NewtonPC Options screen (
Figure 14 ). Record this number and
contact Customer Service to obtain the License Key if you have not
been given this number already. Refer to Contacting Grass Valley
on
page 2 for contact information.
Note When the Newt-Route option is ordered, a License Key form should accom-
pany the option when it is shipped. This document will also describe how to
obtain the License Key.
5. Enter the License Key code you have been given and select the Submit
button.
Figure 14. NewtonPC Options Screen
A confirmation message will appear if the License Key was accepted and
the Router Interface Option will report
Enabled on the NewtonPC Options
screen ( Figure 14 ).
If an invalid code was entered, the message shown in Figure 15 will appear.
Figure 15. Invalid License Key Entered
Device ID